Using Hyperterminal with BUFFALO
Hyperterminal is a communication software
program that comes with Windows NT and Windows 95/98. It can be used
as a terminal window for interacting with BUFFALO on your 68HC11 module.
Configuring HyperTerminal.
-
Locate the HyperTerminal software program
in the Windows menu system.
It is under , , .
-
You will need to set up the com port
configuration.
-
Go to the HyperTerminal properties setup.
-
Click on the Connect To tab.
-
Make the appropriate "CONNECT USING"
selection (eg. Direct to COM2).
-
Click on the CONFIGURE button, and select
"9600, 8, None, 1, and None" for the settings; then click OK.
-
If you expect to be loading code into
EEPROM, you'll need a 10 ms delay. Click on the SETTINGS tab.
-
Click on the ASCII Setup button.
-
Enter 10 milliseconds for the Character
delay, and click OK.