Using Hyperterminal with your 68HC11
Module
Hyperterminal is a communication software
program that comes with Windows NT and Windows 95/98. It can be used
as a terminal window for interacting with the demo program (or your own
application) on your 68HC11 module.
Configuring HyperTerminal.
-
Locate the HyperTerminal software program
in the Windows menu system.
It is under , , .
-
You will need to set up the com port
configuration.
-
Go to the HyperTerminal properties setup.
-
Click on the Connect To tab.
-
Make the appropriate "CONNECT USING"
selection (eg. Direct to COM2).
-
Click on the CONFIGURE button, and select
"2400, 8, None, 1, and None" for the settings; then click OK. (Note:
2400 baud is the rate the demo program expects in standard (ie. 8 MHz)
boards. If you have a "turbo" board, see your manual for the correct
baud rate.)